How to replace the rollers and adjust the X axis shaft?
Replace the rollers:
Adjustment of X-axis shaft
1.Please check before adjustment
①Hold and shake it to check if it becomes loose.(can’t be wobble obviously)
②In the back of X Axis Shaft have four rollers, both of them should locate on the rail.(can move smoothly)
2.Introduction of the X Axis shaft
① The X Axis Shaft
② Eccentric gears, which was for adjusting the tension of X Axis Shaft
③ Rollers
The tools you needed as follow：（M2/M3 Allen Wrench and Crimp Tool inside the tool box）
3. Adjustment of the X Axis Shaft
①Make sure the all screws of the four Rollers are tight enough. However, the X Axis shaft is loosen.
②Adjust the two Eccentric gears as follow：
First , Hold the screws back of the Eccentric gears;
Next, loose the A screws ;
Then, Rotate B by Crimp Tool to tighten the X A
xis Shaft.
Make sure all the Rollers are at the same tension
③repeat step 1 to check again.
End.
Related Articles
How do I replace the X-axis belt
X-axis belt replacement and adjustment Tools needed M3 Screwdriver Plier 5.5mm wrench New belt A pair of scissors Masking tape Disassemble Turn off the machine and unplug the power cord. Remove the upper front door with keys that came with the ...X-axis not moving at all
Reasons: 1. X-axis limit switch problem X-axis limit switch is located on the left side of x-axis, like below. We have installed three limit switches before, and Omron is the one we are using now. Mechanical limit switch: Slot limit switch: Omron ...How to adjust the verticality between the X and Y Axis?
X Axis Turn off the whole machine power. There are four screws for each side, loosen them then you can fine tuning the angle of the X Axis. Shown as bellow. Diagonal line 1 = Diagonal line 2. Error value must be less than 0.5mm like below: ①If ...How to adjust and replace the motor?
X-axis Motor 1. Firstly, disconnect the machine from its power source. Screw A: There are four screws A, for fixing the X motor; Screw B: It’s for adjusting the belt tension, please loosen the four screws A before adjust belt. 2. Click the link ...Y-axis not moving at all
Reasons: 1. Rotary switch is turned on For 5-pin machine, the rotary-axis and y-axis can be switched, if the rotary switch is turned on, y-axis will not moving at all, and the rotary-axis will need to connect the rotary device. Solution: "I" means ...