How to adjust and replace the motor?

How to adjust and replace the motor?


 X-axis Motor


1. Firstly, disconnect the machine from its power source.


Screw A: There are four screws A, for fixing the X motor;

Screw B: It’s for adjusting the belt tension, please loosen the four screws A before adjust belt.

 

2. Click the link below for instructions video:


X motor disassembly


X motor reassembly


 

 

 

Y-axis Motor

​


1. Firstly, disconnect the machine from its power source.

Screw A: There are three screws A.

Screw B: It’s for adjusting the belt tension, please loosen the three screws A before adjust belt.

Screw C: There are four screws C, for fixing the Y Motor.

 

 

2. Click the link below for instruction video:

Y motor disassembly


Y motor reassembly


 

End.


    • Related Articles

    • How to replace the rollers and adjust the X axis shaft?

      Replace the rollers:   Adjustment of X-axis shaft 1.Please check before adjustment ①Hold and shake it to check if it becomes loose.(can’t be wobble obviously) ②In the back of X Axis Shaft have four rollers, both of them should locate on the rail.(can ...

    • Why noisy while moving laser head front and back, how to adjust?

      When you move laser head front and back, two couplings make a lot of noise. Both sides of transmission shaft are not aligned.    How to fix it? 1.Turn off the whole machine power. 2.Take out the belt by taking down the motor. 1). Loosen three screws ...

    • How do I replace the X-axis belt

      X-axis belt replacement and adjustment Tools needed M3 Screwdriver Plier 5.5mm wrench New belt A pair of scissors Masking tape Disassemble Turn off the machine and unplug the power cord. Remove the upper front door with keys that came with the ...

    • How do I replace the Y-axis belt

      Y-axis belt replacement and adjustment(Take the right side of the Y axis belt as an example) Tools needed M3 Screwdriver Plier 5.5mm wrench New belt A pair of scissors Masking tape Disassemble Turn off the machine and unplug the power cord. Remove ...

    • How to adjust the verticality between the X and Y Axis?

      X Axis Turn off the whole machine power. There are four screws for each side, loosen them then you can fine tuning the angle of the X Axis. Shown as bellow.     Diagonal line 1 = Diagonal line 2.  Error value must be less than 0.5mm like below:   ①If ...