X-axis not moving at all
X-axis limit switch is located on the left side of x-axis, like below.
We have installed three limit switches before, and Omron is the one we are using now.
Mechanical limit switch:
Slot limit switch:
Omron limit siwtch:
Solutions:
1. Please check if the wiring and rocker of switch are well or not.
If yes, go next please. If not, adjust or replace them.
2. Please check if the limit switch is working properly.
Mechanic and Omron limit switch:
Slot limit switch:
How to check if the slot switch is faulty
If limit switch is working improperly, please contact us: tech@thunderlaser.com
2. The interface of x-axis motor have bad connection
The interface is located inside the upper right hand door panel, like below.
Solution:
1. Check if the interface is connected tightly.
If yes, go next please.
2. Unplug the interface and check if it has turned black. like below.
If yes, please contact us to replace the interface.
Please power off the machine when checking the connector.
X-axis driver is located inside the lower right hand door panel, like below.
When the X-axis cannot move, the red light of X-axis driver should be on and flashing, please record the flashing frequency(we need to know it when you contact us)
Solution:
1. Please power off the machine , then swap the X/Y axis drivers according to the video below.
2. After that, power on the machine, check if the machine is resetting normally.
If x-axis still not moving at all, so the x-axis motor is broken;
If the problem shifts to y-axis, the same driver is flashing red light, so this driver is broken.
Please contact us: tech@thunderlaser.com
End.
Related Articles
Y-axis not moving at all
Reasons: 1. Rotary switch is turned on For 5-pin machine, the rotary-axis and y-axis can be switched, if the rotary switch is turned on, y-axis will not moving at all, and the rotary-axis will need to connect the rotary device. Solution: "I" means ...How do I replace the X-axis belt
X-axis belt replacement and adjustment Tools needed M3 Screwdriver Plier 5.5mm wrench New belt A pair of scissors Masking tape Disassemble Turn off the machine and unplug the power cord. Remove the upper front door with keys that came with the ...How to replace the rollers and adjust the X axis shaft?
Replace the rollers: Adjustment of X-axis shaft 1.Please check before adjustment ①Hold and shake it to check if it becomes loose.(can’t be wobble obviously) ②In the back of X Axis Shaft have four rollers, both of them should locate on the rail.(can ...How to adjust the verticality between the X and Y Axis?
X Axis Turn off the whole machine power. There are four screws for each side, loosen them then you can fine tuning the angle of the X Axis. Shown as bellow. Diagonal line 1 = Diagonal line 2. Error value must be less than 0.5mm like below: ①If ...How do I replace the Y-axis belt
Y-axis belt replacement and adjustment(Take the right side of the Y axis belt as an example) Tools needed M3 Screwdriver Plier 5.5mm wrench New belt A pair of scissors Masking tape Disassemble Turn off the machine and unplug the power cord. Remove ...