Parameter comparison

If you are calculating cutting speed into your ROI and are trying to decide what wattage you need, you may want to have a look at this:

​

• Related Articles

• Thunder laser tips wood cutting

  When we use just the right power and speed to cut,there is no excessive charring of the cutting area. As we reduce the cutting speed the charring of the cutting edges deepens. As we increase the cutting power the charring of the cutting area also ...

• Manuals for Aurora software

  EzCad2 User's Manual Please see attached EzCad3 User's Manual Please see attached END

• How to upgrade the firmware

  Note: The firmware must be provide by Thunderlaser.

• How to improve engraving quality in the scan mode of X-swing

  The engraving quality working on x_swing is generally worse than x_unilateralism, it usually results in ghosting effect or image offset or bi-directional engraving offset, like below. Notice : We generally use plywood or acrylic to test. x_swing ...

• The RF tube won’t fire the beam?

  Problem Description: The RF tube won't fire the beam even the laser switch is on.  Reasons: 1. The temperature of RF tube is too high. If the temperature of RF tube is too high, RF tubes won't emit beam.  Solution: Please off the machine and wait 4-5 ...