How to install the handle
Tool needed
Installation
- Place the handle on the outside of the hole and the screws on the inside of the hole.
- Fix the screws by hand firstly.
- Then, fix the screws with the tool( using the end that the diameter is 14mm).
Related Articles
How to install and calibrate the lightburn camera
Aurora Series User's Manual
Aurora Series User's Manual Please see attached Manuals for Aurora software Please refer this link:Manuals for Aurora software (thunderlaser.com.au) ENDUSB connection-RDWorks
1. Connect the laser machine and PC with the USB cable that came with the machine. 2. Install the software, please install the USB driver first before press "Install". 3. Open RDWorks and test the connection as following: 4. Then you can ...Why USB connection is not working-RDWorks
Reasons: 1. USB cable is loose or faulty Solution: Unplug the USB cable and plug it back, try again. If re-plug the cable, problem still exists. 2. USB driver is not installed successfully Before you install the software, please install the USB ...RDWorks plug-in installation instructions
RDWorks plug-in installation instructions