NOTE: its a good idea to tape it up first and view it before you stick it down. The mounts are 3d printed and the adhesive is strong. Removal would likely break it. If you happen to get it upside down (many do) that's no big deal, just take out the ...
There is a lot of information (and misinformation) floating around about LightBurn's camera feature as they relate to Thunder Laser machines. There are also a lot of questions about what camera works with what laser. We are going to aggregate the ...
1. Two sides of the working table are not of the same height Turn off the whole machine power, manually pull one of the belts of Z axis so as to adjust the up and down of the working table height of this side and calibrate the level in this way. ...
Tool needed Installation Place the handle on the outside of the hole and the screws on the inside of the hole. Fix the screws by hand firstly. Then, fix the screws with the tool( using the end that the diameter is 14mm).