Tools Required: Slotted screwdriver Allen Wrench 1 piece of Masking Tape 1 safety goggles Warning Do not operate the laser with the side door open. Alignment will be performed with out risk of exposure to laser beam. Be careful please. The corners of ...
Problem description: The laser tube won't fire the beam even the laser switch is on. Reasons: 1. The laser beam path is out of aligned If the laser beam path is out of aligned, the beam cannot comes out from laser head. Solution: Paste a piece of ...
Problem Description: The RF tube won't fire the beam even the laser switch is on. Reasons: 1. The temperature of RF tube is too high. If the temperature of RF tube is too high, RF tubes won't emit beam. Solution: Please off the machine and wait 4-5 ...
When you move laser head front and back, two couplings make a lot of noise. Both sides of transmission shaft are not aligned. How to fix it? 1.Turn off the whole machine power. 2.Take out the belt by taking down the motor. 1). Loosen three screws ...
Problem description: You can not see a red dot comes out from laser head. Reasons: 1. The red dot pointer is off Locate on the Red Dot Pointer Mount in the rear of the machine, and check if the Red Dot Pointer is off, like below. Solution: Please ...