Fire Risk - Never leave your machine unattended

Fire Risk - Never leave your machine unattended

We hear it all the time, don't run the laser unless you are monitoring it. 


This is from a client (VIDEO BELOW):

PSA: I am guilty of reading about not leaving the laser unattended, but doing it anyway. An employee was cutting some acrylic and we are not in the habit of watching it when running. 




There were 2 other employees working within 15 feet of the laser, but the fire was able to burn for 6 minutes before being noticed and put out with a fire extinguisher. 


The employees were running other production machines and did not see or smell the fire as is was contained in the enclosed machine. An employee used an ABC extinguisher. We were lucky the fire didn't do worse damage to the machine or building. 



Best guess as to the cause...we were using some orange plastic supports under the acrylic to avoid nicks on the edge of the cuts. We think the laser ignited the plastic under the acrylic and started the fire. 



Lessons learned. don't leave the machine unattended when cutting, don't use flammable items as supports, also looking into some type of auto fire suppression system.


HERE IS THE FULL VIDEO:





Luckily Thunder's tempered glass viewing windows kept the fire contained. If the machine had acrylic viewing windows, the outcome could have been much worse. 



On the note about automatic fire suppression, have a look at this:

https://www.blazecutusa.com/





Here is what the aftermath looked like:








END

    • Related Articles

    • SAFETY INFO: Class 4 C02 Laser Radiation, PPE, & Fire Suppression

      Overview This document covers some basic safety information on the processes of laser engraving. DISCLAIMER: Laser Engravers emit deadly high voltage and laser radiation capable of causing instant blindness and tissue damage. Lasers are a fire ...
    • The RF tube won’t fire the beam?

      Problem Description: The RF tube won't fire the beam even the laser switch is on.  Reasons: 1. The temperature of RF tube is too high. If the temperature of RF tube is too high, RF tubes won't emit beam.  Solution: Please off the machine and wait 4-5 ...
    • Why the laser tube won’t fire the beam

      Problem description: The laser tube won't fire the beam even the laser switch is on. Reasons: 1. The laser beam path is out of aligned If the laser beam path is out of aligned, the beam cannot comes out from laser head. Solution: Paste a piece of ...
    • The machine won't turn on

      Reasons: 1. Emergency Stop key is pressed Solution: If it’s pressed, please reset it, like below. 2. The circuit breaker has tripped Locate on the lower right-hand door panel (or back side door panel). Solution: Please check if it’s in off position, ...
    • Why does the machine beep continuously

      Problem description: You can hear a beep continuously that comes from the indicates light, even if the machine is rebooted.      Reasons: 1. Temperature sensing probe is bent The heat alarm sensor board is installed in the middle under the X-axis ...