Ethernet cable connection-RDWorks

How to connect with a Ethernet cable

Connect the laser cutter system to desktop or laptop via an Ethernet cable.

1. Configure computer 

Go to Start >> Control Panel >> Network and Sharing Center, configure the connection for local 

connection, like below.

In the Properties window select Use the following IP Address: Set the address to 192.168.1.30

and the subnet Mask to 255.255.255.0, like below.

2. Configure laser cutter software Add and select the Web port.

Click below link to see instruction video:

How to connect the laser machine via Ethernet cable

 

END.

• Related Articles

• USB connection-RDWorks

  1. Connect the laser machine and PC with the USB cable that came with the machine.   2. Install the software, please install the USB driver first before press "Install".  3. Open RDWorks and test the connection as following:   4. Then you can ...

• How to run several laser machine with one PC via Ethernet cable-RDWorks

  If there is an Ethernet hub in your network, it’s able for one PC (laser software) to connect with several machines. But pc will does only communicate with one machine and sending the file into the laser in the same time. 1. Ethernet hub setup PC to ...

• How to run several laser machines with one PC via USB cable connection

  If there are several USB interfaces with your PC, it’s able for one PC (laser software) to connect with several machines. pc to hub , one port of the hub goes to laser But For USB connection as below, 1. Pc to hub , one port of the hub goes to laser. ...

• How to setup wireless network connection for Thunderlaser machine

  Here's what you'll need: A computer with wireless capability A wireless router An Ethernet cable A Thunder laser system Step: 1. router setup Use the Ethernet cable to connect the wireless router to the Ethernet port on your laser system. Connect the ...

• Why USB connection is not working-RDWorks

  Reasons: 1. USB cable is loose or faulty Solution: Unplug the USB cable and plug it back, try again. If re-plug the cable, problem still exists. 2. USB driver is not installed successfully Before you install the software, please install the USB ...