Alarm message of LCD panel-Frame X/Y Slop over
Problem description:
LCD panel shows the following information:
Reason:
1.The size of the graphic is larger than the working area of the machine
Solution：
If your laser cutter's working area is 600×400mm, but you want to cut a graphic which larger than 600×400mm, this warn appears. Since the laser is not able to work beyond its working.
2.Incorrect starting point
Solution：
If you set an incorrect starting point, the graphic might be out of bounds. Please set a correct starting point to resolve this problem, like below.
End
Related Articles
Alarm message of LCD panel--Machine protected(New type sensor)
Problem description: LCD panel shows the following information: Reasons: 1.The door with sensor not close Our machine has sensors for door protection, we've installed 5 door sensors totally. 2 mounted at top flap, 1 mounted at the front door, 1 ...Alarm message of LCD panel-Water error
Problem description: LCD panel shows the following information: Reasons: 1. Water chiller（water pump）is not turned on The switch in the red circle in the picture is not turned on. Solution: Please turn on the water chiller before power on the ...Alarm message of LCD panel--Machine protected（Old type sensor)
Question: LCD panel shows the following information: Reasons: 1. The doors with sensor are not closed Our machine has protection sensors for door (front cover and laser tube cover), like below. Solution: Please close all the doors before starting ...Alarm message of LCD panel-No enough extend space
Problem description: LCD panel shows the following information: Reason: 1.This problem only appears on engraving mode, it's caused by the buffer distance is out of bound. For example, if you want to engrave a picture of 200×200mm, you move the laser ...LCD panel keeps showing"Connecting to controller"
Problem description: The LCD panel keeps showing "Connecting the controller" even if reboot the machine. Reasons: 1. Controller board is faulty The controller board is faulty. Solution: Turning the machine on, open the right side door and see if ...